A complete CAT 5, twin pump, variable speed, constant pressure, cold water tank, and booster set.
2000-Litre GRP WRAS approved cold water storage tank.
MAX Head Meters: 46. Max Flow L/Min: 140
Typical duty: 90 L/Min @ 3.5 Bar
All programmed, tested and ready to go!
This industry-leading booster set and break tank incorporates two state-of-the-art pumps, two E-series variable speed pump controllers, a 24-litre pressure vessel, brass nickel-plated ball valves, stainless steel fittings, 2000-litre GRP break tank assembled on a custom made, powder-coated base plate.
This water pressure booster set is designed to increase the pressure of the water services within a building where the existing incoming mains or feed tank is not capable of supplying sufficient water pressure.
The Booster Pumps
State-of-the-art WRAS approved pumps that are built to last. Thick sheet metal casing, high-quality bearings, and stainless steel guarantee a long service life.
Thanks to its premium build quality these pumps have a low noise level (even at peak performance) a compact design and are extremely energy-efficient, giving you much lower operating costs.
The Pump Controllers
Operation Mode: Duty/standby (can be duty/assist at your request) variable speed controlled.
The incorporated E-Series variable speed pump controllers continually vary the pumps motor speed to match the changing flow demand pattern, whilst maintaining constant system pressure. This mode of operation, adjusting the pump’s motor speed to the building’s flow requirements, reduces the power consumption and extends the pump’s life dramatically.
The pump controller is mounted in the discharge pipework. The body is constructed from a techno-polymer suitable for potable water applications. It has an LCD display to indicate system overview and operating parameters. Complete with dry running, over temperature and over current protection and alarms.
The Break Tank
1500-litre nominal capacity and manufactured to BS 13280:2001 standard using high-quality glass reinforced polyester (GRP) resins.
It has 25mm of encapsulated foam insulation and an 18mm thick encapsulated plywood baseboard.
The tank is WRAS approved and fully CAT 5 compliant complete with type AB air gap back-flow prevention.
It is fitted with a raised chamber and 1″ equilibrium ball valve and drop arm.
As mentioned this booster set and break tank is CAT 5 compliant. However, it can be supplied to comply with different fluid categories such as CAT 4 at your request.
This booster set must be installed undercover, protected from the weather and freezing.
• Conveyed water temperature 0 – 50°C
• Max relative humidity 50% at +40°C
Delivery To Site
This cold water tank and booster set will be delivered to site with a large delivery lorry (average dimensions, length 10.5 meters x width 2.5meters x height 4 meters).
However, if your delivery access is restricted and/or isn’t suitable to accept a large lorry. Please contact us to have your booster set delivered on a smaller vehicle for an additional cost.
In both cases, the system will be delivered on a pallet to the curbside. It is the customer’s responsibility to move the system from this point to where it will be installed/stored.